T3-Micro
The T3-Micro is a Tracker3 in a USB dongle form factor, presently in beta testing. It includes an on-board GPS receiver, and its only external connections are USB and a radio port. Power is provided over the USB connector. The T3-Micro can be connected to a PC, run from a cigarette lighter USB adapter in a vehicle, or powered standalone with a USB battery pack.
No enclosure is presently available for the T3-Micro.
Pinout (3.5mm TRRS connector, starting with tip):
| Pin | Function |
|---|---|
| Tip | Audio out (to mic) |
| R1 | PTT (open collector) |
| R2 | Audio in (from speaker) |
| Sleeve | Ground |
PTT Setup
The T3-Micro has no jumpers. Handheld PTT mode, required for most handhelds except those by Kenwood and most Chinese imports, is set using the command HTPTT ON, or the "HT PTT" checkbox in otwincfg.exe located in the Radio Interface panel. When setting the option in otwincfg, you must first write the new configuration before the change will take effect.
Firmware build 56471 or later must be loaded for the HTPTT command to function.
On-Board GPS
The NMEA pass-through option (NMEAPASS ON or "NMEA P/T" in otwincfg) can be enabled to pass NMEA GPS data through from the on-board GPS receiver to the host. This applies to both console mode and KISS mode.
The GPS receiver operates at 9600 baud and is connected to port A. Set port A to 9600 baud and AUTO mode for normal operation.
APRSISCE/32 Setup
For use with APRSISCE/32, set the USB KISS option in otwincfg and set the interval to 0 to disable automatic transmissions by the tracker. Create a new SimplyKISS port in APRSISCE/32 and enable the GPS/NMEA and message options. The baud rate setting is ignored.
