File list
From ArgentWiki
This special page shows all uploaded files.
| Date | Name | Thumbnail | Size | Description | Versions |
|---|---|---|---|---|---|
| 20:07, 1 March 2009 | Opentracker-ot2m.jpg (file) |  |
89 KB | OT2m | 1 |
| 20:08, 1 March 2009 | Opentracker-ot2m-board.jpg (file) |  |
161 KB | OT2m board | 1 |
| 20:09, 1 March 2009 | Opentracker-ot2m-rear.jpg (file) |  |
90 KB | OT2m rear | 1 |
| 20:11, 1 March 2009 | Opentracker-t2-135.jpg (file) |  |
66 KB | T2-135 | 1 |
| 20:13, 1 March 2009 | Opentracker-t2-135-installed.jpg (file) |  |
51 KB | T2-135 installed | 1 |
| 20:15, 1 March 2009 | Otplus-case.jpg (file) |  |
79 KB | OT+ case | 1 |
| 20:16, 1 March 2009 | Otplus-rev1 1.jpg (file) |  |
260 KB | OT+ rev 1.1 | 1 |
| 20:18, 1 March 2009 | Otplus-smt.jpg (file) |  |
45 KB | OT+ SMT | 1 |
| 07:49, 3 September 2009 | OT2m Temperature Sensor.png (file) |  |
28 KB | Closeup photo of the LM335D temperature sensor chip used on the OT2m. | 1 |
| 07:56, 3 September 2009 | OT2m Voltage Divider.png (file) |  |
38 KB | Close up of the voltage divider circuit on the OT2m. | 1 |
| 08:06, 3 September 2009 | OT2 MON08.png (file) |  |
59 KB | Close up photo of the MON08 pin header on the OT2m. | 1 |
| 09:54, 3 September 2009 | OT2 Accessory.png (file) |  |
147 KB | Accessory port on the front panel of the OT2m. | 1 |
| 10:56, 3 September 2009 | OT2m Reporting Options.png (file) |  |
3 KB | OT2m Reporting options section from OTWINCFG. | 1 |
| 12:20, 3 September 2009 | OT2 MON08 pinout.png (file) |  |
26 KB | OT2 MON08 pinout diagram | 1 |
| 06:50, 30 October 2009 | Nuvimap.png (file) |  |
51 KB | Sample Nuvi Map screen with APRS icons | 1 |
| 06:51, 30 October 2009 | Nuvilist.png (file) |  |
11 KB | APRS station list on the Nuvi 350 | 1 |
| 18:09, 31 March 2011 | OT2-Moto.png (file) |  |
64 KB | Changed audio input from pin 2 Ext Mic Audio to pin 5 Flat TX Audio Input. Pin 2 has 500 ohm input impedence, and OT2 is not able to drive the input level high enough to create more than 2 kHz deviation. Pin 5 input impedence is 35K, which OT2 can drive e | 2 |
| 17:59, 26 September 2011 | Voltage divider.jpg (file) |  |
70 KB | Added resistors to create a second voltage divider. | 1 |
| 18:00, 26 September 2011 | Config.jpg (file) |  |
33 KB | Configuration input | 1 |
| 20:03, 26 September 2011 | Interface.jpg (file) |  |
101 KB | Backside I/O connections. | 1 |
